The No Scoria Drainage Solution
The QuickDrain solution is designed for the economic removal of excess ground water in residential areas, pasture, cropland, orchards, playing fields, roading and construction work. It is effective to use foreffluent soakage fields, retaining wall drainage and stormwater diversion.
QuickDrains’ engineered drainage solution provides a scoria-free alternative to traditional scoria drainage solutions, cutting installation time in half.
The QuickDrain solution incorporates a recycled polystyrene aggregate that provides enhanced drainage performance, strength, filtration and longevity.
The QuickDrain solution is a faster and easier install than traditional drainage solutions
Click to enlarge
Quick Drain New Zealand made
QuickDrain is manufactured in New Zealand to strict quality control procedures, as the performance of the product is dependent on the accurate formation of the knit structure of the sleeve, the polystyrene and pore in the pipe.
QuickDrain for superior filtration
High performance recycled polystyrene filling does not clog and efficiently filters out excess sediment. It delivers a high performance flow effectively draining excess water away quickly.
QuickDrain is strong and lightweight
The QuickDrain pipe is made from a High-Density Polyethylene (HDPE) material, with a corrugated profile wall to give high crush resistance, flexibility and lightness. It has slots cut at the bottom of the corrugations and spaced around the circumference.
QuickDrain tested and proven
Made from Polyester the QuickDrain Filter Sleeve® is a tested and proven solution for protecting subsoil drains from sedimentation. It works by trapping the sand particles and assisting the formation of a soil filter around the pipe.
Where to use:
EXPOL QuickDrain is designed to be used in residential and light commercial non-traffic drainage applications.
- Sports Field
QuickDrain can be used in many drainage situations.
- QuickDrain comes in easy to handle 2.5 metre lengths. Each length comes with a QuickDrain Joiner.
- Dig your trench the same width as your QuickDrain and deep enough to allow a minimum of 200mm of soil coverage.
- Simply clip the length together to achieve the required length for your project. Once the QuickDrain has been laid in the trench you are ready to start covering the QuickDrain.
Position your QuickDrain
Join your QuickDrain
Lay your QuickDrain
Fill in with soil
QuickDrain Joiner – Make sure the indent in the joiner goes over coil ridge – check it is secure
Put the joiner on end of the QuickDrain and align with other end of QuickDrain
Push the QuickDrain pipe with the joiner over other QuickDrain pipe
Make sure the indent in the joiner goes over coil ridge – check it is secure
Measure the length required
Cut the cable tie and remove excess polystyrene
Push sleeve and polystyrene down pipe to required length. Retie with new cable tie supplied, trim excess sleeve off
Cut pipe – ensure you leave enough pipe so it will accommodate joiner